The Patriot Clone has a 22mm top cap which provides lots of room for different types of coil and wick combinations. The cap has two pre-drilled holes on each side which can be drilled out for maximum vapor production. The Patriot has a standard 510 connector and can be used on a large variety of mods.
Features
Rebuildable Dripping Atomizer
510 Thread Connector
Stainless Steel Top Cap and Base
Can be setup as a single/dual coil configuration
Deep Juice Well
2 Pre-Drilled Airflow Holes
Delrin Insulator
Laser Engraved Logo
22mm Diameter
Three Phillips Head Screws For Positive/Negative Posts
2 Medical Grade O-rings Seal the Top Cap to the Body
Cooling fins on the top of the cap to dissipate heat
The Patriot Clone was my first RDA. It was the perfect head to learn on as there is plenty of room to work. The posts have holes/screws to hold the coils in place. This makes things easy. You simply loosen the screws, insert the wire, and tighten them back up.
I like it as it looks good on my stainless steel Vamo 2. They look like they were made for each other. The RDA sits flush on top and if I didn't know better, I would think they were designed, built, and sold together. This is a solid head that performs well and is very affordable.
The Patriot Clone's main selling points, or features, are its deep well and high cap which in combination equate to more air flow and more room for wick. This in turn equates to more juice and less frequent refilling. The 22 mm size makes for a flush look on most mods. The heat sink fin adds interest as far as looks are concerned and removes up to 50% more heat when chain vaping. This keeps it from heating up and burning your lips. The large well and spacey contact points allow room for coil design and ease of use. It is easy to create both dual and quad coil set-ups as there is plenty of room to work. Overall, the patriot Clone RDA is very user friendly.
No comments:
Post a Comment